Differences

This shows you the differences between two versions of the page.

--- enc_4_4 [2018/03/06 07:46]
latigid_on [BOM v1.0]
+++ enc_4_4 [2018/03/06 18:45]
latigid_on [Dimensions]
@@ Line 47: / Line 47: @@
 ===== Assembly =====
+Decide on the configuration to be used. Any combination of switches, encoders or OLEDs is possible if they fit.
+Only one encoder is wired to the J1 header. If you want to use the EN2 position, wire the legs to the empty EN1 solder points.
+R9 and C29 form the power-on reset for OLEDs. R7 should not be installed. R3/C25/R4/C26 form a termination shunt for OLED data lines. They shouldn't be required.
+The switches accommodate either DT6 or 6mm switches (obviously only one type!). For DT6 switches, ensure the flat side is aligned with the PCB silkscreen.
+J2 can supply power if needed.
@@ Line 53: / Line 61: @@
 ==== Interconnections ====
-  * J1
+{{::scsoled:j1.png?nolink&200|}}
+J1 is the SCS header, connecting to J10A
-===== Dimensions =====
+J2 can provide power as indicated; it is also connected on J5.
-{{:encs:encs.png?link&400|}}
+J5 connects to J15 on the Core (or equivalent)
+===== Dimensions =====
-{{ :encs:encs_dxf.zip }}
+{{ :scsoled:doku.zip |}}
+{{:scsoled:scsoled.png?link&600|}}
 ===== License =====

MIDIbox