This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
mb-lre8x2cs_rev4.6 [2014/02/25 04:46] fairlightiii [Schematic] |
mb-lre8x2cs_rev4.6 [2014/04/04 13:55] fairlightiii [Pictures] |
||
---|---|---|---|
Line 28: | Line 28: | ||
====Pictures==== | ====Pictures==== | ||
+ | |||
+ | |Actual PCB| | ||
+ | |{{http://midibox.org/forums/uploads/gallery_7662_237_87413.jpg?800 |Top_Rev_4.7!}}| | ||
+ | |{{http://midibox.org/forums/uploads/gallery_7662_237_94830.jpg?800 |Bottom_Rev_4.7!}}| | ||
+ | |||
==Mix of the Rev2.5 and protoboard pictures (Note this is not the last versions but they have practically the same dimensions and LEDs/Encoders positioning):== | ==Mix of the Rev2.5 and protoboard pictures (Note this is not the last versions but they have practically the same dimensions and LEDs/Encoders positioning):== | ||
Line 188: | Line 193: | ||
Be careful when sourcing SIL resistor networks because a 6 Pin SIL resistor network can be 5 commoned resistors (what you need here) or __3__ independant resistors. | Be careful when sourcing SIL resistor networks because a 6 Pin SIL resistor network can be 5 commoned resistors (what you need here) or __3__ independant resistors. | ||
- | A point on the silkcreen prevent to solder upside-down the resistor networks (a point is also indicated on the resistor network). | + | A dot on the silkcreen prevent to solder upside-down the resistor networks (a dot is also indicated on the resistor network). |
==Polarized Electrolytic Capacitor 100 uF== | ==Polarized Electrolytic Capacitor 100 uF== |