This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
mbqg_fp [2021/01/31 16:21] smithy |
mbqg_fp [2024/02/02 15:01] (current) smithy [MIDIbox Quad Genesis: Front Panel] |
||
---|---|---|---|
Line 4: | Line 4: | ||
To build the front panel of MIDIbox Quad Genesis, you will need (details on each part below): | To build the front panel of MIDIbox Quad Genesis, you will need (details on each part below): | ||
- | * An aluminum front panel **OR** 3D Printed Front Panel (See Below) | + | * An aluminum front panel **OR** PCB Front Panel from Smithy ([[http://midibox.org/forums/topic/19678-midibox-quad-genesis/?do=findComment&comment=200872|See forum post]]) **OR** 3D Printed Front Panel (See Below) |
* A PCB to hold all the buttons, LEDs, encoders, etc., and of course all these electronic components themselves | * A PCB to hold all the buttons, LEDs, encoders, etc., and of course all these electronic components themselves | ||
* A bunch of 3D printed transparent button caps | * A bunch of 3D printed transparent button caps |