User Tools

Site Tools



This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
mf_ng_module [2006/10/15 09:35] (old revision restored)
mf_ng_module [2016/08/05 19:27] (current)
psykhaze [Introduction]
Line 1: Line 1:
-MF Module is used to control Motorfaders ​from the Midibox+====== Motorfader-NG ​Module ​====== 
-    * [[|MF Module]] ​<sup>uCApps</​sup>​+ 
 +{{ :​neonking:​mbhp_mf_v3_proto1.jpg?​500 |}} 
 +The MF_NG module ​is the successor of the MBHP_MF module and has following design targets: 
 +  * find a solution ​to handle high-quality faders like Alps K faders with "​coreless"​ motors 
 +  * find a solution for Core32 which doesn'​t deliver stable enough ADC conversion results due to the reduced 3.3V voltage range 
 +  * find a solution for Core32 which cannot handle touch sensors properly without heavy CPU load (resp. without an additional external device or microcontroller) 
 +  * find a solution which is compatible with PIC based projects for best usability 
 +  * find a solution which is DIY friendly and doesn'​t require additional gear for something which isn't part of the MBHP yet 
 +  * find a solution which can be easily tested and troubleshooted (no need to learn new processes) 
 +{{ ::​neonking:​mbhp_mf_ng_final1.jpg?​600 |}} 
 +And the result is: 
 +  * a dedicated **PIC controller** controls the motorfaders directly. 
 +  * the firmware can be updated via MIDI! 
 +  * **motorfaders are accessed via MIDI** - this allows standalone usage, cascading (to chain multiple modules), and the re-use of existing infrastructure such as MIOS, MIOS Studio and MIOS Bootloader 
 +  * **the module can either be connected to a PC directly, or controlled ​from a second PIC or STM32**  
 +  * native support of various protocols (e.g. PitchBender,​ CCs, even Logic Control and Mackie Control Emulation) 
 +  * support for 8 touch sensors 
 +  * instead of TC4427 I'm using L293D now - not at least because of the integrated diodes
 +  due to the direct motor control connections,​ **the PIC is now able to generate PWM with 50 uS steps for improved motor speed control** while a motor is moved 
 +  * since the firmware is dedicated for this task, there was enough memory free to integrate advanced features, such as **runtime-calibration and motor position tracing** which are supported by MIOS Studio 
 +===== Parts List ===== 
 +see [[mf_ng_board_parts_list|MF_NG Parts List]] 
 +  * {{​mbhp/​mbhp_mf_ng.pdf|Schematic}}<​sup>​UCapps</​sup>​ 
 +===== Compatible Motorfaders ===== 
 +  * ALPS RASON11M9 {{​MF_NG_connection_diagram.pdf|Interconnection Diagram}}<​sup>​UCapps</​sup>​ 
 +===== PIC Source Code ===== 
 +  * {{http://​​mbhp/​|MF_NG PIC Code}}<sup>UCapps</​sup>​
mf_ng_module.1160904901.txt.gz · Last modified: 2007/09/28 07:03 (external edit)