This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
msq-cc-lre [2018/10/10 00:54] phatline [Hardware Requirements] |
msq-cc-lre [2018/10/10 00:55] phatline |
||
---|---|---|---|
Line 2: | Line 2: | ||
MotionSeQuencer for ControlChanges for 2xLRE8x2 Boards\\ | MotionSeQuencer for ControlChanges for 2xLRE8x2 Boards\\ | ||
Synth-Patch-Editor & Motion-Sequencer 4 ControlChange (= CC-Automation)\\ | Synth-Patch-Editor & Motion-Sequencer 4 ControlChange (= CC-Automation)\\ | ||
- | {{:phatline:MSQ_CC_LRE_Thumbnail.jpg?700|}}\\ | + | {{:phatline:MSQ_CC_LRE_Thumbnail.jpg?600|}}\\ |
{{youtube>A_17FqmB53Y}}\\ | {{youtube>A_17FqmB53Y}}\\ | ||
Line 36: | Line 36: | ||
* [[home:mbhp:module:core32]]\\ | * [[home:mbhp:module:core32]]\\ | ||
* [[http://ucapps.de/mbhp_midi_io.html|1xMidi IO]] connect 1 midicontroller and 1 Note/Clock-Source/Destination\\ | * [[http://ucapps.de/mbhp_midi_io.html|1xMidi IO]] connect 1 midicontroller and 1 Note/Clock-Source/Destination\\ | ||
- | * SD-Card, formated with FAT32, and the file "bcr1.syx" on it\\ | + | * SD-Card, formated with FAT32\\ |
* Soldering Iron, Wires, PCB....\\ | * Soldering Iron, Wires, PCB....\\ | ||
- | * USB Power Supply... I tried to use the Midi-BUS-Power from BCR2000 but it is too weak! | + | * USB Power Supply\\ |
* 2x LRE 8x2 [[mb-lre8x2cs_pcb]] | * 2x LRE 8x2 [[mb-lre8x2cs_pcb]] | ||
* 3 extra Encoders and Ledrings (to controll the unit) + Pushfunction inclusive Button LED | * 3 extra Encoders and Ledrings (to controll the unit) + Pushfunction inclusive Button LED |