wcore_i2c
Differences
This shows you the differences between two versions of the page.
| Next revision Both sides next revision | |||
|
wcore_i2c [2017/09/10 13:06] latigid_on created |
wcore_i2c [2017/09/10 13:08] latigid_on [Assembly] |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| Building is straightforward with all part values indicated (consider 33pF caps in place of 16pF). Start with the flattest components (resistors, caps, crystals, IC sockets) and work up to the higher ones. Ensure the DIN sockets are snug against the PCB before soldering caps all of the pins! Make sure resistor legs etc. don't inadvertently short out with metal parts such as the sockets and the crystal cans. | Building is straightforward with all part values indicated (consider 33pF caps in place of 16pF). Start with the flattest components (resistors, caps, crystals, IC sockets) and work up to the higher ones. Ensure the DIN sockets are snug against the PCB before soldering caps all of the pins! Make sure resistor legs etc. don't inadvertently short out with metal parts such as the sockets and the crystal cans. | ||
| + | |||
| + | ===== Programming ===== | ||
| + | |||
| + | PICs require flashing with a special version of MIOS as indicated on [[http://www.ucapps.de/mbhp_iic_midi.html|the uCapps page]]. | ||
wcore_i2c.txt ยท Last modified: 2018/12/18 09:39 by latigid_on
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
