This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
wcore_line-transmit [2017/09/11 22:07] latigid_on [BOM v1.0] |
wcore_line-transmit [2017/09/11 22:09] latigid_on [Schematic] |
||
---|---|---|---|
Line 7: | Line 7: | ||
[[http://www.ucapps.de/mbhp/mbhp_line_driver_transmitter.pdf|MBHP Transmitter]]. | [[http://www.ucapps.de/mbhp/mbhp_line_driver_transmitter.pdf|MBHP Transmitter]]. | ||
- | The two obvious differences are the J3 jumper (disconnects +5V from being sent) and the addition of a 100mil header. This way a DB-25 connector (or something else?) with ribbon cable mounting could be mounted off-board and connected to the line driver with an IDC. | + | The two obvious differences are the J3 jumper (disconnects +5V from being sent) and the addition of a 100mil header. This way a DB-25 (or something else?) with ribbon cable mounting could be positioned off-board and wired to the line driver with an IDC. |
---- | ---- |