wilba_mb_6582_control_surface_construction_guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wilba_mb_6582_control_surface_construction_guide [2009/10/04 13:28] Wilba |
wilba_mb_6582_control_surface_construction_guide [2009/10/17 14:31] Kyo |
||
|---|---|---|---|
| Line 81: | Line 81: | ||
| Insert LEDs. **CHECK THEY ARE IN CORRECTLY ALIGNED** | Insert LEDs. **CHECK THEY ARE IN CORRECTLY ALIGNED** | ||
| - | The flat side of the LED should match the flat side of the symbol on the PCB. The flat side has the cathode. Also the shorter lead is the cathode. http://en.wikipedia.org/wiki/LED#Considerations_in_use | + | The flat side of the LED should match the flat side of the symbol on the PCB. The flat side has the cathode. Also the shorter lead is the cathode. [[http://en.wikipedia.org/wiki/LED#Considerations_in_use]] |
| Put the PCB in the PT-10 case top where the panel would normally go, so the LEDs can be put in without bending the leads. | Put the PCB in the PT-10 case top where the panel would normally go, so the LEDs can be put in without bending the leads. | ||
wilba_mb_6582_control_surface_construction_guide.txt ยท Last modified: 2020/12/15 15:13 by m00dawg
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
