Unlike in V1, V2 has no Varitions (4 Variations for each Song/Programchange)
Var1 Switch (upper 1st button) = Store Patch
Var2 Switch (upper 2nd button) = Load Patch


U S E R   M A N U A L:

Velocity Assign / Velocity Morph:   
        What is:
        The Velocity from the Triggers which are comeing from your Sequencer/or Triggerpad, can change the Synths-Parameters > i call that "Velocity Morph"
    
        How to enter:
        "Velocity Morph" Mode is entered by press and HOLD the "Velocity Assign" Button, which is the Pushbutton of the First right upper Encoder of your BCR.
    
        How to change Morph ammount:
        while press and hold "Velocity Assign Button", you take your other hand and turn it left or right...
        left or right?...
            middle: cc_value = 63; default value - with no effect (see "Velocity CLEAR ALL" to clear all Assignments @ once)
            left:  min cc_value = 0;     0 will reduce your CC-Encoder-Value    with   full Velocity Ammount (of the currently played note...)
            right: max cc_value = 127; 127 will add +64 to your CC-Encoder-Value
                but wait... will it? no! unless you turn the "Velo_Morph_Offset" Encoder - clockwise...
    
        How to   Offset  the Morph ammount   for one track    for all CCs     @ ONCE?
            what happens turned left or right?:
                left: NO VALUE will be addet to your CC-Encoder-Value   ( doesnt matter if you set a "Velo_Morph" or not )
                middle: half "morph_ammount" +- to your CC-Enc-Val (+ - depends on morph ammount polarity)
                right: full "morph_ammount" to your CC-Enc-Value

        The Velocity Morph is only Active if the "Motion-Sequencer-Active-Button" is activated - so it is switched with the Motion-Sequence...
        ... but there must no be a Motion-Sequence Recordet ...
        The Velocity Morph can only effect if there is a Midi-Master-Clock connect to MidiPort A (MIOS internal called Port 32), the clock must run...

Velocity Assign "CLEAR ALL":
        Erase all Velocity Assignments for this Track,   earse means that it is set to VALUE 63, which is middle position.
        it is a good starting point to do that, because, if all (in this version there are 29) Encoders are offset, means that every 32th Step 29 CCs over 8 Midichannels
        are sent out..., even if you turn the "Morph ammount" Rotarys   to    Middle Position   you have to set it exact to Value "63" 64 will not have much effect on sound
        but it will be sent out a CC-Value out... and this will reduce the Performance of the Device, so this is a real live saver for hanging Presets, which are destroit of
        invalid  sd-storage  data  and that or ported Patches... press "Velocity Assign Clear All" & "Motion Sequencer Clear All" on all 8 tracks and you are good ;)

        
    
