Differences

This shows you the differences between two versions of the page.

--- mbhp_genesis [2017/08/18 21:11] – [Parts list] sauraen
+++ mbhp_genesis [2026/02/20 06:51] (current) – [Component stuff chart] smithy
@@ Line 1: / Line 1: @@
-{{http://midibox.org/forums/uploads/monthly_2015_11/large.mbhp_genesis_1e_front.jpg.97a341757653897ba6218555ea690650.jpg?640}}
+{{http://midibox.org/forums/uploads/monthly_2015_11/large.mbhp_genesis_1e_front.jpg.54c08f42d0fd242b1039f5e83a067ddd.jpg?640}}
 ====== Summary ======
@@ Line 141: / Line 141: @@
 | 1 | Y2 or Y4 | 3.58 MHz (or 4 MHz) oscillator | 520-TCH357-X | Oscillator (either half-size/8-DIP or 5x7mm SMD) at desired PSG frequency. MIDIbox Genesis firmware will correct frequencies to match original VGM pitch. |
 | 3 | Q1, Q2, Q3 | 2N7000 or BS170 | 821-TSM2N7000KC821-T or 512-BS170 | Any small-signal N-channel MOSFET with the gate as the center pin; the board silkscreen is for 2N7000, if you use BS170 (as I did) mount them backwards to match the source and drain pins. |
-| - | J1, J2, J7, J10 | 0.1" stackable pin socket/headers | 782-A000086 | Pin sockets with long pins (from Arduino shields), for stacking the boards together. Buy in bulk and combine them for the appropriate sizes. Use a regular pin header for the lowest board in the stack; have each header mounted with the socket below the board and the pins sticking out the top. See this photo of the stack. |
+| - | J1, J2, J7, J10 | 0.1" stackable pin socket/headers | 782-A000086 | Pin sockets with long pins (from Arduino shields), for stacking the boards together. Buy in bulk and combine them for the appropriate sizes. Use a regular pin header for the lowest board in the stack; have each header mounted with the socket below the board and the pins sticking out the top. See [[http://midibox.org/forums/uploads/monthly_2017_08/large.finished_inside2.jpg.459682a854f131f34f39a57ba6cdb27a.jpg|this photo]] of the stack. |
 | - | J5, J6, J8 | 0.1" pin headers | Buy in bulk | Headers; J5 and J6 are individual on each board if used, and J8 is only on the final board. |
-| - | J10 | 0.1" dual row pin headers | Buy in bulk | Headers; J10 connects all boards together, so put sockets on one side of the boards and have the pins sticking through on the other sides. |
 | 1 | L1 | 10 uH inductor | 434-SMCCN-100K-02 | For LC filter for analog power rail |
 | 2 | C12, C13 | 100 uF electrolytic | Buy in bulk | Power rail filter caps |
@@ Line 175: / Line 174: @@
 The values I used for my quad builds are on the schematic and in the parts list. The normal values are for use with YM2612s, and the values in parentheses are the ones to use with YM3438s. All other parts which just show one value are the same on both builds.
 ===== Component stuff chart =====
-Here is a chart of what components should be stuffed on each build configuration I could think of. In most cases, several of these build configurations will be active at the same time (e.g. in a typical four-board setup, the top board is A, B or C, D, (E), F, G, H, I, M. Note that MIDIbox Quad Genesis requires F, G, H, I).
+Here is a chart of what components should be stuffed on each build configuration I could think of. In most cases, several of these build configurations will be active at the same time (e.g. in a typical four-board setup, the top board is A, B or C, D, (E), F, G, H, M. Note that MIDIbox Quad Genesis requires F, G, H).
 ^ Label ^ Description ^
@@ Line 198: / Line 197: @@
 ^ Parts ^ A ^ B ^ C ^ D ^ E ^ F ^ G ^ H ^ I ^ J ^ K ^ L ^ M ^ N ^ O ^ P ^
-| U1, C1, C14, C15, Y1 or Y3, C20, C21, R11, R12, R15, R16, C23, C24, R18, R19, R21, R22 | X |   |   |   |   |   |   |   |   |   |   |   |   |   |   |   |
+| U1, C1, C14, C15, Y1 or Y3, C20, C21, R11, R12  | X |   |   |   |   |   |   |   |   |   |   |   |   |   |   |   |
 | R8, R9 |   | X |   |   |   |   |   |   |   |   |   |   |   |   |   |   |
 | R33, R34 |   |   | X |   |   |   |   |   |   |   |   |   |   |   |   |   |
-| U2, C2, Y2 or Y4, U10, C10, Q2, Q3, R4:6, R10, C22, R13, R17, C25, R20, R23, R24 |   |   |   | X |   |   |   |   |   |   |   |   |   |   |   |   |
+| U2, C2, Y2 or Y4, U10, C10, Q2, Q3, R4:6, R10, C22, R13 |   |   |   | X |   |   |   |   |   |   |   |   |   |   |   |   |
-| J1, C12, L1, C13, C11, U4, C4, C16, R31, R32, C18, C19, U5, C5, C17, R25, R26, C29, C30, C31, C32, R27:30, J8 | X |   |   | X |   |   |   |   |   |   |   |   |   |   |   |   |
+| J1, C12, L1, C13, C11 | X |   |   | X |   |   |   |   |   |   |   |   |   |   |   |   |
 | J6, R7 |   |   |   |   | X |   |   |   |   |   |   |   |   |   |   |   |
 | U7, C7 |   |   |   |   |   | X | X |   |   |   |   |   |   |   |   |   |
 | U8, C8 |   |   |   |   |   | X | X | X |   |   |   |   |   |   |   |   |
 | U6, C6, Q1, R1 |   |   |   |   |   |   | X |   |   |   |   |   |   |   |   |   |
-| U9, C9, C26:28 |   |   |   |   |   |   |   | X |   |   |   |   |   |   |   |   |
+| U9, C9 |   |   |   |   |   |   |   | X |   |   |   |   |   |   |   |   |
 | J5 |   |   |   |   |   |   |   |   | X |   |   |   |   |   |   |   |
 | Short U3:5 to U3:15 |   |   |   |   |   |   |   |   |   | X |   |   |   |   |   |   |
@@ Line 213: / Line 212: @@
 | Short U8:3 to U8:6  |   |   |   |   |   |   |   |   |   |   | X | X |   |   |   |   |
 | U3, C3, J2 |   |   |   |   |   |   |   |   |   |   |   | X | X |   |   |   |
+| U4, C4, U5, C5, C16:19, C23:32, R15:32, J8  |   |   |   |   |   |   |   |   |   | X | X | X | X |   |   |   |
 | Short U3:13 to J3:2, short U3:12 to J3:1 |   |   |   |   |   |   |   |   |   |   |   |   |   | X |   |   |
 | Short U3:11 to J3:2, short U3:10 to J3:1 |   |   |   |   |   |   |   |   |   |   |   |   |   |   | X |   |