euro-midi-io
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
euro-midi-io [2022/02/06 06:31] – [PCB] phatline | euro-midi-io [2022/02/11 15:20] – [EuroRack - Midi IO - Board] phatline | ||
---|---|---|---|
Line 10: | Line 10: | ||
{{: | {{: | ||
+ | |||
+ | FIXME - The Connection from J1 to J2 is wrong - its 1:1 but it has to be crossed.\\ | ||
====== Hardware Requirements ====== | ====== Hardware Requirements ====== | ||
* Soldering Iron - with a Dip that can Handle Thruhole-Parts and 1206 SMDs, solder Paste...\\ | * Soldering Iron - with a Dip that can Handle Thruhole-Parts and 1206 SMDs, solder Paste...\\ | ||
Line 81: | Line 83: | ||
====== Frontpanel====== | ====== Frontpanel====== | ||
{{: | {{: | ||
- | **I made a DXF File which you can print, and drill it DIY or \\ | + | **I made a {{: |
- | you can send to:** (once the prototypestate is gone)\\ | + | you can send to:**\\ |
- | [[https:// | + | [[https:// |
- | [[https:// | + | I tested one with them - and yes they looking good - and they fit!:\\ |
- | [[https:// | + | \\ |
+ | another good guy: [[https:// | ||
\\ | \\ | ||
**Recommend Material**\\ | **Recommend Material**\\ | ||
2mm x 128.5 x 17.78 Aluminium, anodised\\ | 2mm x 128.5 x 17.78 Aluminium, anodised\\ | ||
- | {{: | ||
\\ | \\ | ||
**A cheaper way is: order a 1,6mm thick Aluminium PCB as Frontpanel: | **A cheaper way is: order a 1,6mm thick Aluminium PCB as Frontpanel: | ||
- | I will test this... | + | this are the gerbers:\\ |
+ | {{: | ||
+ | I have testet it, and this 1.6mm Aluminium from JLCPCB is too thin, i endet up by sandwith 2 off them togehter - so its strong enough, since the Labels are reversed when use the PCB reversed - i now removed them in this gerber file!\\ | ||
{{: | {{: | ||
+ | |||
euro-midi-io.txt · Last modified: 2022/02/11 15:23 by phatline