Differences

This shows you the differences between two versions of the page.

--- ainser8_module [2016/08/04 09:33] – [Inputs/ Outputs Port Table] psykhaze
+++ ainser8_module [2016/08/04 23:51] (current) – [Introduction] psykhaze
@@ Line 22: / Line 22: @@
 **Powering the module via USB (provided at J19 by the core module) is sufficient**. It's recommended to use a "selfpowered" USB Hub like this one from Reichelt. It also decouples the power from the (noisy) PC supply, and allows to run the MIDIbox without a PC connection.
 \\
+===== Parts List / Schematic =====
+See [[ainser8_board_parts_list|AINSER8 Parts List]]
+\\
+  * {{http://ucapps.de/mbhp/mbhp_ainser8.pdf|Schematic}}<sup>UCapps</sup>
 ===== Inputs/ Outputs Port Table =====
+^ Port ^ Pins # ^ Description                                                                            ^
+| J2   | 10     | Serial input which is usually connected to J19 of MBHP_CORE_STM32F4 module.            |
+| J3   | 10     | Serial output which could be used to chain multiple MBHP_AINSER* modules.**Please note: the standard AINSER driver for MIOS32 doesn't support this method!** Instead it expects that multiple modules are connected to J19 in parallel, and that they are using dedicated chip select lines (selected via jumper J4)!        |
+| J4   | 3      | A jumper has to be connected to this port to select the first or second chip select line of J2 for accessing the ADC.  |
+| J6   | 10     | 8 analog inputs and 5V (=Vd) / Ground (=Vs) connections.**Please note: all unused analog inputs have to be clamped to ground (Vss)**, otherwise your MIDIbox will send out a lot of random MIDI events |