Differences

This shows you the differences between two versions of the page.

--- aout_ng [2018/03/05 01:32] – [Parts List] goyousalukis
+++ aout_ng [2018/03/15 17:29] (current) – Added some mouser parts numbers goyousalukis
@@ Line 56: / Line 56: @@
 |IC3,IC4    |OpAmp                  |TL074   |2        |TL 074 DIL          |595-TL074IN          |
 |           |Sockets for OpAmps     |14-pin  |2        |GS 14               |571-1-2199298-3      |
-|J1,J2      |Pin Header Single Row  |none    |2        |see below           |see below            |
+|J1,J2      |Pin Header Single Row  |none    |2        |see below           |855-M20-9994045      |
-|J3,J4      |Pin Header Single Row  |none    |2        |see below           |see below            |
+|J3,J4      |Pin Header Single Row  |none    |2        |see below           |855-M20-9994045      |
-|JP1,JP2,J5 |Pin Header Dual Row    |none    |3        |see below           |see below            |
+|JP1,JP2,J5 |Pin Header Dual Row    |none    |3        |see below           |571-5-146254-8       |
-|LED1       |LED 3 mm               |none    |1        |LED 3MM GN          |                     |
+|LED1       |LED 3 mm               |none    |1        |LED 3MM GN          |604-WP132XID         |
 |P1-P8      |Precision Trimpot(64Y) |5k      |8        |64Y-5,0k            |594-64Y502           |
 |R1-R8      |Metal Film Resistor 1% |27k     |8        |METALL 27,0K        |594-MBB02070C2702FC1|
@@ Line 244: / Line 244: @@
 **Midibox SEQ V4**
-Press the EXIT button, enter the CV configuration page, and select the AOUT_NG interface.
+Press the EXIT button, use the scroll wheel to enter the CV configuration page, and select the AOUT_NG interface.
-This page also allows you to calibrate the CV outputs (volunteers: please add description for this process)
+This page also allows you to calibrate the CV outputs. Select the AOUT channel you wish to calibrate (1-8) using the first encoder. Press the button underneath the Calibr. label and turn the encoder to select a calibration voltage. The options are: Min/Middle/Max/1V, 2V, 4V, 8V. Turn the encoder until the 1V is selected. Measure the voltage at the channel you are calibrating. It should equal 1V. If it doesn't, adjust the trimpot P1(for the first channel) until the multimeter reads 1V. Follow the process for each voltage. It normally is not possible to get each voltage perfectly set. The goal is to get all of the voltages as close to the target as possible.
+Once the calibration is complete, turn the encoder until 'OFF' is showing.
 **Midibox CV V1**