Differences

This shows you the differences between two versions of the page.

--- envelope-follower-bissel-based [2021/01/05 22:58] – [To Do] phatline
+++ envelope-follower-bissel-based [2021/01/22 02:06] (current) – [Envelope Follower] phatline
@@ Line 2: / Line 2: @@
 based on Harry Bissel\\
 a SMD Variant, ready for Pick and Place\\
+open-hardware, all Kicad-Files, and Gerbers are includet!\\
 {{:phatline:ENV-Follower-3D-rotate.png?500|}}\\
 --shown 2 identical boards on one pcb - to save money..
@@ Line 85: / Line 86: @@
 ===== To Do =====
-frontplate, Debugging First Version\\
+frontplate\\
-experiment with the Smooting CAP, i already implimented a Header wich is paralell to a integrated 100nF Cap, so you could connect there a CAP to encrease the smoothing\\
+Debugging First Version\\
-experiment with the Frequency Pot which is a lin10K + 1K Serial Resistor which gives a range of 1K-12K - i also made a Header here, which you can bridge then you have 1-12K, or you put a resistor there for example a 5K, then you will get a range from 6-16K... \\
+**experiment with the Smooting CAP:** a Header is connected paralell to a integrated 100nF Cap, connect there a CAP to encrease the smoothing\\
+**experiment with the Frequency Pot:** a lin10K + 1K internal Serial Resistor which gives a range of 1K-12K - i also made a Header here, which you can bridge then you have 1-12K, or you put a resistor there for example a 5K, then you will get a range from 6-16K... \\
 I addet some Jumpers to break the circuit for debugging or measurement\\
 \\
@@ Line 99: / Line 101: @@
 [[https://www.muffwiggler.com/forum/userpix2/10917_bom_1.jpg|THT-PCB-BOM]]\\
 [[https://www.muffwiggler.com/forum/userpix2/32564_scr01_2.png|Haralds-Hi-Clock-Measurements]]\\
-I give this links because it is the source: but i cant recommend that forum! (deletes of posts, shitstorm, not constructive posts...)
+I give this links because it is the source: but i cant recommend that forum! (deletes of posts, shitstorm, non constructive posts...)
 ====== Community users working on it ======
   * **[[Phatline]]** =  Programming, Documentation...\\