Differences

This shows you the differences between two versions of the page.

--- fantomxr [2015/01/21 12:28] – fantomxr
+++ fantomxr [2015/01/21 12:37] (current) – fantomxr
@@ Line 3: / Line 3: @@
 On this page I will list pcb designs I made. Some are tested, some are not. I will add a note to every PCB.
+Most of them are not that special. But they make the midibox-life easier.
 \\
 \\
@@ Line 54: / Line 55: @@
 {{:fantomxr_8xswitch.png?500|}}
+\\
+\\
 ==== Fatar keybed adapter ====
@@ Line 70: / Line 73: @@
 Status: **untested**\\
-Eagle *.brd: [[https://www.dropbox.com/s/y5kh9n5zghuzk0v/DIO-Adapter 8 auf 2x6pin.brd?dl=0|Download]]
+Eagle *.brd: [[https://www.dropbox.com/s/evby49o42hru6yt/DIO-Adapter%208%20auf%202x6pin.brd?dl=0|Download]]
 {{:fantomxr_dio_6pin.png?500|}}
@@ Line 77: / Line 80: @@
 \\
+==== DIO Adapter 1x10pin ====
+Same as above but for 10pin. Can also be chained.
+Status: **untested**\\
+Eagle *.brd: [[https://www.dropbox.com/s/7flat7vsjr9vqbb/DIO-Adapter%208%20auf%201x10pin.brd?dl=0|Download]]
+{{:fantomxr_dio_10pin.png?500|}}
+\\
+\\
+==== 10pin splitter ====
+This is an adapter for split an 10pin pinheader into 2x 6pin. This is useful, if you want to connect two of my 4x switchboards directly to a DIN module.
+Status: **untested**\\
+Eagle *.brd: [[https://www.dropbox.com/s/ru4wxj5p2mrh3mv/10%20auf%202x3.brd?dl=0|Download]]
+{{:fantomxr_10pin_split.png?200|}}
+\\
+\\
+==== USB I/O ====
+Because the Neutrik USB jack which comes in a D-housing is quite expensive, I set up this little board.
+Status: **tested**\\
+Eagle *.brd: [[https://www.dropbox.com/s/8d4t99wnr1p62hb/USB-Platine.brd?dl=0|Download]]
+{{:fantomxr_usb_platine.png?200|}}
+\\
+\\