pickit2
                Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| pickit2 [2009/01/25 19:04] – chr0n1c | pickit2 [2011/09/16 23:47] (current) – dougster | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| - | //This page is here in hopes of helping somone else avoid having to go through what i did in figuring it all out.// | + | //This page is here in hopes of helping somone else avoid having to go through what i did in figuring it all out.(--chr0n1c)// | 
| The Pickit2 USB Programmer WILL generate the required voltages for HVP programming of the chip. | The Pickit2 USB Programmer WILL generate the required voltages for HVP programming of the chip. | ||
| - | It is possible to program  | + | It is possible to program  | 
| - | **1. BUILD THIS ICSP ADAPTER**  | + | **1. BUILD THIS ICSP ADAPTER** | 
| + | In order to do HVP with this circuit, you will need to short | ||
| the jumper going to pin 38 of the pic18f452. | the jumper going to pin 38 of the pic18f452. | ||
| - | ...will insert my schematic  | + | ...will insert my schematic  | 
| Line 39: | Line 40: | ||
| **9. PULL THE CHIP FROM THE PROGRAMMING ADAPTER AND INSERT IT TO YOUR MBHP_CORE.** | **9. PULL THE CHIP FROM THE PROGRAMMING ADAPTER AND INSERT IT TO YOUR MBHP_CORE.** | ||
| - | **10. from here, there is plenty of other documents on the wiki describing the next steps...**  | + | **10. from here, there is plenty of other documents on the wiki describing the next steps...** | 
|      LINK: http:// |      LINK: http:// | ||
| + | other forum posts that were helpful in this research... | ||
| - | + |    | |
| - | other froum posts that were helpful in this research... | + |   http:// | 
| - | http:// | + |   http:// | 
| - | http:// | + | |
| - | http:// | + | |
| - | + | ||
pickit2.1232910245.txt.gz · Last modified: 2009/01/25 19:04 by chr0n1c
                
                