Differences

This shows you the differences between two versions of the page.

--- ssm2164_getting_started [2018/04/26 17:03] – [Class A] phatline
+++ ssm2164_getting_started [2018/04/26 19:28] (current) – phatline
@@ Line 2: / Line 2: @@
 seppomans building information;[[ssm2164_pcb]]\\
 the following informations are take from the midibox forum, its a collection of infos, without the claim to be 100% true, i will try to test the given information.
+====== Shematic ======
+not found anywhere... m( \\
+also reverse engeniering/understanding/troubleshooting/moding is nearly impossible when the pcbs are stuffed, because most of the traces are on the component site... or hidden behind the black paint\\\
+--- first i want to know for what are those POTs? Input Gain of Audio? or of CV? or some BIAS? seppoman said nothing...\\
+POT P1 middle & right Pin connected to VCC-\\
+POT P1 left Pin connected to a 27K Resistor and this resistor to a nother 27K Resistor which is connected to CV1+ Input. the middle point of this2xresistors is going to the TL74-OP-Amp Pin1 which is a inverting input...\\
+The Output of this TL74 Stage is Pin1: its connected to Pin 6 SSM2164, which is the CV-Input\\
+When i measure Pin6 to Ground, and Turn P1 most left:1,8V... Turn P1 most right: 2,47V\\
+so what does it? no one said: its a zero offset for bipolar cv? or is it gain-control? FIXME m( \\
 ====== Power ======
@@ Line 73: / Line 84: @@
 SSM2164 Pin 1 (the first pin) sets the "Mode"
 ==== Class AB ====
-Pin is Open, no Resistor to +12V (PCB Default)\\
+Pin 1 is Open, no Resistor to +12V (PCB Default)\\
 Lower  current results in higher distortion/lower noise.\\
+---i do want distortion and dont care about noise--- so i do not change anything, the pcb is fine.
 ==== Class A ====
-Pin is Connected to +12V via a Resistor\\
+Pin 1 is Connected to +12V via a Resistor\\
 Higher current results in lower distortion/higher noise\\
 lets look in the datasheet:\\
 {{:phatline:ssm2164-ab-a.png?600|}}\\
 Figures 11 and 12 show the THD and noise performance of the
-SSM2164 as the bias current is adjusted.  Notice the two
+SSM2164 as the bias current is adjusted\\
-characteristics have an inverse characteristic.\\
-The quiescent current in the core is set by adding a single
-resistor from the positive supply to the MODE pin.\\ the formula for the
-MODE current is:\\
 I_MODE = ( (V+)−0.6V )/ RB\\
 ,52mA = (12V-0.6V) / 7,5K\\
 Leaving the MODE pin open sets the SSM2164 in Class AB with 30 μA in the Gain-Core\\