MIDIbox

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== XYZ-IR-Controller ======
Hack a Alesis PhotonX25 XYZ-Dome-IR controller\\
or how to DIY\\

{{:phatline:xyz-ausfuehrung.JPG?800|}}\\

===== Introduction =====
The XYZ Dome works with 1 IR DIODE, and 4 IR Transistors, which are connected to 2x Stereo Audio ADC 24Bit running on Wordclock...\\
I dont know if i can get the Alesis ADCs running (AL1101) - see Datasheet
{{:phatline:al1101-datasheet.pdf|}} \\
maybe i only remove the DACs and connect them to J5A!

==== PCB/Shematic ====
first a took a shot of the Front&Back of the IR-PCB... then i matched it, and redrawed every path...\\ 
{{:phatline:xyz-pcb-all.JPG?800|}}\\

i removed the orginal picture:\\
{{:phatline:xyz-pcb.JPG?800|}}\\

==== MB MODs ====
How to get it working without touching a SERIAL PROTOCOL?\\
dont using the onboard DACS, instead use the MB-Core STM32F4 J5A AIN-Port....\\ 
{{:phatline:xyz-pcb-mod.JPG?800|}}\\
Negative: using a lot of bandwith.\\

I connected all 4 IR-Transistor-Circuit directly to J5A\\
The IR-Diode I connected to Pin1 of J10A.



====== Hardware Requirements ======

**Midibox:**\\ 
  * [[home:mbhp:module:core32]]\\
  * [[http://ucapps.de/mbhp_midi_io.html|1xMidi IO]] connect 1 midicontroller and 1 Note/Clock-Source/Destination\\


===== To Do =====
all...!\\


====== Community users working on it ======
  * **[[Phatline]]** =  Programming, Documentation...\\