display_driver
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
display_driver [2018/03/08 07:52] latigid_on [Versions] |
display_driver [2018/03/31 13:36] latigid_on |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| The second purpose is to use a chain of shift registers to provide chip select (CS) signals. It is functionally equivalent to a DOUT module, but the header is directly compatible with GPIO on the Core. | The second purpose is to use a chain of shift registers to provide chip select (CS) signals. It is functionally equivalent to a DOUT module, but the header is directly compatible with GPIO on the Core. | ||
| + | |||
| + | |||
| + | The pinout for the display connectors is as follows: | ||
| + | |||
| + | {{:dispdriver:header_j1-j2.png?direct&600|}}\\ | ||
| + | (Power is connected to pin 10.) | ||
| + | |||
| + | |||
| + | |||
| + | |||
| ---- | ---- | ||
| Line 131: | Line 141: | ||
| ==== Dimensions ==== | ==== Dimensions ==== | ||
| - | The PCB is 100*100mm with 3.6mm diameter holes centred 3.5mm from the edges. | + | The PCB is 100*100mm with 3.2mm diameter holes centred 3.5mm from the edges. |
display_driver.txt ยท Last modified: 2018/03/31 13:46 by latigid_on
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
