This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
flo [2010/04/07 16:43] flo |
flo [2012/10/02 06:43] (current) cheater Reverting spam from lauraholden |
||
---|---|---|---|
Line 5: | Line 5: | ||
====== flo user page ====== | ====== flo user page ====== | ||
- | ... under construction ... last edit: 2010-04-07 | + | ... under construction ... last edit: 2010-04-10 |
Line 183: | Line 183: | ||
www.ucapps.de/index.html?page=mios_c_set_dout.html | www.ucapps.de/index.html?page=mios_c_set_dout.html | ||
* DOUT Module, the digital outputs that will be set by the CORE module and will control the FX loopers. \\ | * DOUT Module, the digital outputs that will be set by the CORE module and will control the FX loopers. \\ | ||
+ | NOTE: Only 1/4 of a DOUTx4 module is needed to control 7 relays. \\ | ||
NOTE: When using only 7 FX loopers, DOUT can be omitted. The FX looper board then needs to be connected directly to a CORE header. | NOTE: When using only 7 FX loopers, DOUT can be omitted. The FX looper board then needs to be connected directly to a CORE header. | ||
- | The application then needs to drive that header directly. This is not yet supported but should be relatively simple. \\ | + | The application then needs to drive that header directly. This is not yet supported by MIOS but should be relatively simple. \\ |
www.ucapps.de/index.html?page=mios_c_set_dout.html \\ | www.ucapps.de/index.html?page=mios_c_set_dout.html \\ | ||
\\ | \\ |