lre-oled-bar
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
lre-oled-bar [2022/02/04 14:15] phatline [LRE8x2 096 SSD1306-BAR for Eurorack] |
lre-oled-bar [2022/02/04 14:20] phatline [Frontpanel] |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| {{:phatline:JLCPCB-low-cost.jpg?476|}}\\ | {{:phatline:JLCPCB-low-cost.jpg?476|}}\\ | ||
| And they are working, they also V-Grooved on my marking without extra costs...\\ | And they are working, they also V-Grooved on my marking without extra costs...\\ | ||
| + | My next Revision would be a Micromatch header on the left side of the pcbs so i can directly interconnect to a Display Driver (crimping instead of soldering)\\ | ||
| ====== Hardware Requirements ====== | ====== Hardware Requirements ====== | ||
| * a MIOS32 Core to connect too\\ | * a MIOS32 Core to connect too\\ | ||
| Line 43: | Line 44: | ||
| i panalized it so there are 2 Plates in it\\ | i panalized it so there are 2 Plates in it\\ | ||
| I payed 40€ summed for booth plates incl shipping from Germany to Austria\\ | I payed 40€ summed for booth plates incl shipping from Germany to Austria\\ | ||
| - | {{:phatline:2xLRE-OLED-BAR-DXF.zip?700|}}\\ | + | |
| + | The Version with the not needet 3mm Mounting holes for the LRE8x2:{{:phatline:2xLRE-OLED-BAR-DXF.zip?700|}}\\ | ||
| + | |||
| + | My Orginal Autocad Drawing, + DXFs for Fabrication without the non needet Mounting Holes:{{:phatline:EURO-LRE-Frontpanel.zip?700|}}\\ | ||
| **Recommend Material from Formulor:**\\ | **Recommend Material from Formulor:**\\ | ||
lre-oled-bar.txt · Last modified: 2022/02/04 14:22 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
