m16
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
m16 [2018/09/08 14:10] antichambre [Special command messages] |
m16 [2018/09/30 07:39] antichambre [Features] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * There's a 64 word(32bits) FIFO for out-coming messages from the board. | * There's a 64 word(32bits) FIFO for out-coming messages from the board. | ||
| * 3 independents groups of 16 GPIOs, configurable and settable by SPI Command. | * 3 independents groups of 16 GPIOs, configurable and settable by SPI Command. | ||
| - | * Can be stacked under a [[dipboardf4|dipBoardF4 mbhp]] | + | * Can be stacked under a [[dipboardf4|dipBoardF4]] |
| \\ | \\ | ||
| ==== PCB==== | ==== PCB==== | ||
| Line 158: | Line 158: | ||
| * Enable MIDI activity status messages over SPI(MISO). | * Enable MIDI activity status messages over SPI(MISO). | ||
| - | There's only one MIDI configuration command, for Running Status enabler.\\ | + | There's only one MIDI configuration command, dedicated to UARTs TX(MIDI Out) Running Status enabler.\\ |
| With GPIOx commands, you can configure and set the GPIO ports.\\ | With GPIOx commands, you can configure and set the GPIO ports.\\ | ||
m16.txt ยท Last modified: 2018/10/08 09:12 by antichambre
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
