mb-resynth
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
mb-resynth [2016/08/15 00:48] psykhaze |
mb-resynth [2016/11/12 17:03] psykhaze [Introduction] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ===== Introduction ===== | ===== Introduction ===== | ||
| - | The Midibox Eurosynth project aims to be a **Eurorack Re edit of MIDIbox synths with advanced Control Surfaces** running with a Core32. | + | The Midibox Eurosynth project aims to be a **4U Re edit of MIDIbox synths with advanced Control Surfaces** running with a Core32. |
| It's the Merging of 3 existing projects: | It's the Merging of 3 existing projects: | ||
| Line 17: | Line 17: | ||
| [[Psykhaze]],[[Antichambre]],Eptheca | [[Psykhaze]],[[Antichambre]],Eptheca | ||
| - | ===== Getting Involved ? ===== | ||
| - | Just let a Private message on the forum to some of users already involved | ||
| - | |||
| - | ===== Software Tools used ===== | ||
| - | |||
| - | * **[[inkscape|Inkscape Vector Drawing Software]]** - Front panel Concept Drawing | ||
| - | * **[[kicad|KiCAD PCB]]** - PCB Design | **[[http://smisioto.no-ip.org/elettronica/kicad/kicad-en.htm|KiCAD Librairies]]** | ||
| - | * **[[codeblocks_ide|Code::Blocks Integrated Development environment]]** - GUI Software - MIOS programming | ||
| - | |||
| - | ===== Architecture ===== | ||
| - | {{ ::neonking:eurosynth-architecture.jpg?direct&800 |}} | ||
| - | |||
| - | ==== Standard Main Part Features ==== | ||
| - | |||
| - | - Core32 Board | ||
| - | - **Standard Control Surface** with 6 Tactile switches, Push - Encoder ,**[[OLED]]** Graphical screen | ||
| - | - **SD Card Slot+USB in** | ||
| - | - **2xMIDI IN + 2xMIDI OUT 2.5mm jack Plugs** | ||
| - | ==== Eurorack Relative ==== | ||
| - | |||
| - | * **Eurorack Design 3U Height **//=5,25"=133mm-rails=__**128,5mm**__// . | ||
| - | * **Modules Frontpanels are 8HP-multiple wide** //(8HP=__**40,3mm**__)// see //**[[http://www.doepfer.de/a100_man/a100m_e.htm|Eurorack Specification]]**//. \\ Frontpanel back spacers glued with JB-weld to avoid front screwing. **{{::neonking:eurotemplates.pdf|Eurorack Templates PDF}} | {{::neonking:eurotemplates.zip|Eurorack Templates DXF}}**\\ | ||
| - | * **PCB Size is 100mm height** To stay compliant to **//[[http://www.elma.com/en/services/us-resources/eurocard-specs/|Eurocard Specification]]//** | ||
mb-resynth.txt · Last modified: 2016/11/12 17:03 by psykhaze
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
