This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
peterpressure [2011/12/11 19:16] peterpressure created |
peterpressure [2011/12/12 04:12] peterpressure |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | BLM SCALAR FIX | + | **BLM SCALAR FIX** -Based on findbhudda's original design: http://www.midibox.org/dokuwiki/doku.php?id=findbuddha |
- | Based on findbhudda's design: http://www.midibox.org/dokuwiki/doku.php?id=findbuddha | ||
- | |||
- | |||
- | DESIGN SOFTWARE USED: | ||
-------------------- | -------------------- | ||
- | Same as findbhudda :)\\ | + | DESIGN SOFTWARE USED:\\ |
KiCAD for PCB/Schematics: http://kicad.sourceforge.net/wiki/Main_Page\\ | KiCAD for PCB/Schematics: http://kicad.sourceforge.net/wiki/Main_Page\\ | ||
- | KNOWN ISSUES / BUILD SUGGESTIONS: | ||
-------------------- | -------------------- | ||
+ | KNOWN ISSUES / BUILD SUGGESTIONS:\\ | ||
- blm-scalar.* contain an error. Pins I4-I7 are mirrored. This is easily fixed with a connector modification, and the blm-scalar module seems to work as intended.\\ | - blm-scalar.* contain an error. Pins I4-I7 are mirrored. This is easily fixed with a connector modification, and the blm-scalar module seems to work as intended.\\ | ||
- | - blm-scalar v1.1 attempts to fix this error. Moved connectors J1, J2, Resistor Net 1 and R9 to make room for corrections.\\ | + | - blm-scalar v1.1 attempts to fix this error. Moved connectors J1, J2 & Resistor Net 1 to make room for corrections.\\ |
- | DESIGN FILES: | ||
-------------------- | -------------------- | ||
- | Original files from findbhudda {{:findbuddha:findbuddha-shared-wiki-docs-0.1.zip|}}\\ | + | DESIGN FILES:\\ |
- | Corrected blm-scalar v1.1.brd {{:peterpressure:blm-scalar_v1.1..zip|}} | + | Corrected blm-scalar v1.1.brd below & attached: {{:blm-scalar_v1.1.zip|}}\\ |
+ | \\ | ||
+ | {{:blm_scalar_v1.1.jpg|}}\\ | ||
+ | \\ | ||
+ | Original findbhudda board below:\\ | ||
+ | {{:blm_scalar.brd.old.jpg|}} |