MIDIbox

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== MIDIbox SEQ v3 inside a C64 case, using its keyboard ======

It's possible to save some time and money building the SEQ into a Commodore 64 case and re-purposing the keyboard, so that each key corresponds to each of the buttons expected in the original project.

Note that this is different than using just the chassis: in that case you would make a panel, attach buttons etc. like any other "standard" implementation.

Pros:
  * No buttons required.
  * The C64 case can fit all the needed circuitry of MBSEQ.
  * Only 6 DINs and 6 DOUTs required (or one DINX4, one DOUTX4 and two protoboards).

Cons:
  * The right LCD is misaligned to the corresponding buttons, unless using a "staggered" layout.
  * It's suggested that all the keys should be re-labeled with their new function.

The "kernel" of this mod is both in hardware and in software.
The hardware part is made by a scan matrix circuit which interfaces the Core to the C64 keyboard. It's exactly the one used for [[midiboxkb_-_using_a_c64_keyboard_as_input|MidiBoxKB]].
The software part is a little patch to the SEQ firmware, valid for v3.2 and v3.2a, that uses that circuit to emulate presses/releases of the buttons.

The spare space above the keyboard is then used to hold the encoders and the two 2x40 LCDs. In my own implementation I "extended" the keyboard plane with a panel: this way LCDs and encoders have a more comfortable position when using the sequencer sitting in a desk.


FIXME complete this page!

For any other info, please watch [[http://www.midibox.org/forum/index.php?topic=9452.0|this forum thread]].

[[http://custom-essay-writing-service.org/index.php|essay writing service]]
MIDIbox

User Tools

Site Tools

Page Tools
