ssm2164_getting_started
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
ssm2164_getting_started [2018/04/26 17:04] phatline [Class A] |
ssm2164_getting_started [2018/04/26 17:08] phatline [Class AB] |
||
|---|---|---|---|
| Line 73: | Line 73: | ||
| SSM2164 Pin 1 (the first pin) sets the "Mode" | SSM2164 Pin 1 (the first pin) sets the "Mode" | ||
| ==== Class AB ==== | ==== Class AB ==== | ||
| - | Pin is Open, no Resistor to +12V (PCB Default)\\ | + | Pin 1 is Open, no Resistor to +12V (PCB Default)\\ |
| Lower current results in higher distortion/lower noise.\\ | Lower current results in higher distortion/lower noise.\\ | ||
| + | ---i do want distortion and dont care about noise--- so i do not change anything, the pcb is fine. | ||
| ==== Class A ==== | ==== Class A ==== | ||
| - | Pin is Connected to +12V via a Resistor\\ | + | Pin 1 is Connected to +12V via a Resistor\\ |
| Higher current results in lower distortion/higher noise\\ | Higher current results in lower distortion/higher noise\\ | ||
| lets look in the datasheet:\\ | lets look in the datasheet:\\ | ||
ssm2164_getting_started.txt ยท Last modified: 2018/04/26 19:28 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
