ssm2164_getting_started
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
ssm2164_getting_started [2018/04/26 17:04] phatline [Class A] |
ssm2164_getting_started [2018/04/26 19:28] (current) phatline |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| seppomans building information;[[ssm2164_pcb]]\\ | seppomans building information;[[ssm2164_pcb]]\\ | ||
| the following informations are take from the midibox forum, its a collection of infos, without the claim to be 100% true, i will try to test the given information. | the following informations are take from the midibox forum, its a collection of infos, without the claim to be 100% true, i will try to test the given information. | ||
| + | |||
| + | ====== Shematic ====== | ||
| + | not found anywhere... m( \\ | ||
| + | also reverse engeniering/understanding/troubleshooting/moding is nearly impossible when the pcbs are stuffed, because most of the traces are on the component site... or hidden behind the black paint\\\ | ||
| + | --- first i want to know for what are those POTs? Input Gain of Audio? or of CV? or some BIAS? seppoman said nothing...\\ | ||
| + | POT P1 middle & right Pin connected to VCC-\\ | ||
| + | POT P1 left Pin connected to a 27K Resistor and this resistor to a nother 27K Resistor which is connected to CV1+ Input. the middle point of this2xresistors is going to the TL74-OP-Amp Pin1 which is a inverting input...\\ | ||
| + | The Output of this TL74 Stage is Pin1: its connected to Pin 6 SSM2164, which is the CV-Input\\ | ||
| + | When i measure Pin6 to Ground, and Turn P1 most left:1,8V... Turn P1 most right: 2,47V\\ | ||
| + | so what does it? no one said: its a zero offset for bipolar cv? or is it gain-control? FIXME m( \\ | ||
| + | |||
| ====== Power ====== | ====== Power ====== | ||
| Line 73: | Line 84: | ||
| SSM2164 Pin 1 (the first pin) sets the "Mode" | SSM2164 Pin 1 (the first pin) sets the "Mode" | ||
| ==== Class AB ==== | ==== Class AB ==== | ||
| - | Pin is Open, no Resistor to +12V (PCB Default)\\ | + | Pin 1 is Open, no Resistor to +12V (PCB Default)\\ |
| Lower current results in higher distortion/lower noise.\\ | Lower current results in higher distortion/lower noise.\\ | ||
| + | ---i do want distortion and dont care about noise--- so i do not change anything, the pcb is fine. | ||
| ==== Class A ==== | ==== Class A ==== | ||
| - | Pin is Connected to +12V via a Resistor\\ | + | Pin 1 is Connected to +12V via a Resistor\\ |
| Higher current results in lower distortion/higher noise\\ | Higher current results in lower distortion/higher noise\\ | ||
| lets look in the datasheet:\\ | lets look in the datasheet:\\ | ||
ssm2164_getting_started.1524762284.txt.gz ยท Last modified: 2018/04/26 17:04 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
