wcore
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wcore [2017/09/16 09:44] latigid_on [Burning the bootloader] |
wcore [2017/09/16 09:45] latigid_on [Burning the bootloader] |
||
|---|---|---|---|
| Line 53: | Line 53: | ||
| The MCU module has a USB port, but direct programming would only be possible with a USB-UART programmer. It would also require a different bootloader protocol. Instead, we make use of SWD functionality. The MCU module has a typical JTAG/SWD header and these pins are also available on the two 2*25 header rows. | The MCU module has a USB port, but direct programming would only be possible with a USB-UART programmer. It would also require a different bootloader protocol. Instead, we make use of SWD functionality. The MCU module has a typical JTAG/SWD header and these pins are also available on the two 2*25 header rows. | ||
| - | I believe that the BOOT CONFIG switch should be set to system, although I think this is more relevant for flashing through UART rather than SWD. | + | I believe that the BOOT CONFIG switch should be set to SYSTEM, although I think this is more relevant for flashing through UART rather than SWD. |
| ==== Option 1: ST-LINK clone ==== | ==== Option 1: ST-LINK clone ==== | ||
wcore.txt ยท Last modified: 2017/09/18 06:07 by latigid_on
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
