This is an old revision of the document!
====== wCoreF4 ====== ===== Introduction ===== This is a cross-grade of the STM32F4 Core based on the [[http://www.waveshare.com/wiki/Core407V|Core407v]] breakout board from Waveshare. There are other versions of breakouts, but the Waveshare one seems quite a reputable source with decent distribution and documentation. ==== Pros ==== * Slightly smaller footprint * (Almost) all connectors on same face * Proper USB A and B ports * Footswitch/gate 3.5mm jack * Hardware host/slave switch * LEDs on the panel * Reset button on the panel * User button on header * More mounting options available (e.g. panel mount including USB) * 1A 3v3 regulator * Possibility for external Vref (for AIN) ==== Cons ==== * Similar height to Disco version (could cut off headers etc.) * Lacks ST-LINK and requires a (cheap) programmer or a Discovery module * No mounting holes on MCU breakout * Requires SMT soldering (wide pitch) ===== Sub parts ===== The Core is split over three PCBs: [[wCoreF4 PCB]] [[wCore USB]] [[wCore RES-SD]] Build instructions are found on the appropriate pages. ===== MCU module ===== The actual MCU module is available from several sources: ===== Burning the bootloader ===== The MCU module has a USB port, but direct programming would only be possible with a USB-UART programmer. It would also require a different bootloader protocol. Instead, we make use of ST-LINK-like functionality. The MCU module has a typical JTAG header and these pins are also available on the two 2*25 header rows. So even if the header had to be removed for space reasons, it should always be possible to re-flash the MCU. ==== Option 1: ST-LINK clone ==== These are readily available from eBay and other sellers for typically <$10. You only require one programmer to flash as many modules as needed. ==== Option 2: use a Discovery module ==== The Discovery module (even if connected to a MIDIbox Core) can be used for programming. ---- ==== License ==== Currently the design is (c) 2016 antilog devices with all rights reserved; all documentation is CC BY-NC-SA 3.0.
