This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
wcoref4_pcb [2017/10/04 22:01] latigid_on |
wcoref4_pcb [2018/06/29 10:50] latigid_on [Connecting the Core407v breakout] |
||
---|---|---|---|
Line 97: | Line 97: | ||
* The 407v board should not protrude past the edge of the PCB. | * The 407v board should not protrude past the edge of the PCB. | ||
* Remove the OTG jumpers "FLG," "VBUS" and "PWR OUT." USB won't work properly with these closed. | * Remove the OTG jumpers "FLG," "VBUS" and "PWR OUT." USB won't work properly with these closed. | ||
- | * I believe that the correct state of the BOOT CONFIG switch should be set to "SYSTEM" | + | * I believe that the correct state of the BOOT CONFIG switch should be set to "FLASH" |
* There's another switch to select the +5V power. It should be set to "USB" when flashing the board using the USB mini connector as a power source, but for our purposes set it to "PWR 5V". | * There's another switch to select the +5V power. It should be set to "USB" when flashing the board using the USB mini connector as a power source, but for our purposes set it to "PWR 5V". | ||