wilba_mb_6582_base_pcb_construction_guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wilba_mb_6582_base_pcb_construction_guide [2009/10/19 19:33] Kyo |
wilba_mb_6582_base_pcb_construction_guide [2009/12/15 07:24] Kyo |
||
|---|---|---|---|
| Line 318: | Line 318: | ||
| Don't forget R80. This resistor is required for the CAN Bus to function. If you populated all the Cores and they aren't working, then you probably forgot R80. | Don't forget R80. This resistor is required for the CAN Bus to function. If you populated all the Cores and they aren't working, then you probably forgot R80. | ||
| - | |||
| - | |||
| ====== Finished? ====== | ====== Finished? ====== | ||
| Maybe not. Go read the notes at the end of this page: | Maybe not. Go read the notes at the end of this page: | ||
| - | http://www.midibox.org/dokuwiki/wilba_mb_6582 | + | [[http://www.midibox.org/dokuwiki/wilba_mb_6582]] |
| ====== Base PCB Revision 1 Errors ====== | ====== Base PCB Revision 1 Errors ====== | ||
| - | http://www.midibox.org/forum/index.php?topic=9781 | + | [[http://www.midibox.org/forum/index.php?topic=9781]] |
| - | http://www.midibox.org/forum/index.php?topic=9775 | + | [[http://www.midibox.org/forum/index.php?topic=9775]] |
wilba_mb_6582_base_pcb_construction_guide.txt ยท Last modified: 2012/05/03 23:38 by wilba
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
