xyz-ir-controller
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
xyz-ir-controller [2020/02/07 00:18] phatline |
xyz-ir-controller [2020/02/09 02:32] phatline |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| or how to DIY\\ | or how to DIY\\ | ||
| - | {{:phatline:xyz-ausfuehrung.JPG?600|}}\\ | + | {{:phatline:xyz-ausfuehrung.JPG?800|}}\\ |
| ===== Introduction ===== | ===== Introduction ===== | ||
| Line 13: | Line 13: | ||
| ==== PCB/Shematic ==== | ==== PCB/Shematic ==== | ||
| first a took a shot of the Front&Back of the IR-PCB... then i matched it, and redrawed every path...\\ | first a took a shot of the Front&Back of the IR-PCB... then i matched it, and redrawed every path...\\ | ||
| - | {{:phatline:xyz-pcb-all.JPG?600|}}\\ | + | {{:phatline:xyz-pcb-all.JPG?800|}}\\ |
| i removed the orginal picture:\\ | i removed the orginal picture:\\ | ||
| - | {{:phatline:xyz-pcb.JPG?600|}}\\ | + | {{:phatline:xyz-pcb.JPG?800|}}\\ |
| + | |||
| + | ==== MB MODs ==== | ||
| + | How to get it working without touching a SERIAL PROTOCOL?\\ | ||
| + | dont using the onboard DACS, instead use the MB-Core STM32F4 J5A AIN-Port....\\ | ||
| + | {{:phatline:xyz-pcb-mod.JPG?800|}}\\ | ||
| + | Negative: using a lot of bandwith. | ||
xyz-ir-controller.txt · Last modified: 2020/02/09 05:14 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
