Differences

This shows you the differences between two versions of the page.

--- euro-midi-io [2022/02/06 06:54] – [Frontpanel] phatline
+++ euro-midi-io [2022/02/11 15:23] (current) – [To Do] phatline
@@ Line 10: / Line 10: @@
 {{:phatline:EURO_Midi_IO_Shematic.jpg?900|}}\\
+FIXME - The Connection from J1 to J2 is wrong - its 1:1 but it has to be crossed.\\
 ====== Hardware Requirements ======
   * Soldering Iron - with a Dip that can Handle Thruhole-Parts and 1206 SMDs, solder Paste...\\
@@ Line 77: / Line 79: @@
 so feel free to test - and report!\\
 {{:phatline:EURO_Midi_IO_Board.jpg?900|}}\\
+FIXME - dont use this - because of J1-J2 connection is wrong (this matter if you chain 2 Midi-IO-Modules\\
@@ Line 86: / Line 89: @@
 I tested one with them - and yes they looking good - and they fit!:\\
 \\
-If you are in the UK you may contact: [[https://thebeast.co.uk/2d/|The Beast - UK]]\\
+another good guy: [[https://thebeast.co.uk/2d/|The Beast - UK]]\\
 \\
@@ Line 101: / Line 104: @@
 ====== To Do ======
-Since i already debugged Rev.A - and this is the overworked Rev.B - there should not be much to do, except to test the gerber filers... i am happy with Rev.A (have still PCBs so no check of RevB in near future!)\\
+Use a other Midi-OUT-Activity Shematic! - its not working for high speed midi! - while Note-ON off is ok, Midiclock can make trouble (the Charge-Discharge Circuit in this Design is not sufficent for this!)\\
 ====== Community users working on it ======