mididocs:seq:blm16x16_build_guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| mididocs:seq:blm16x16_build_guide [2016/03/31 11:42] – [Parts notes] latigid_on | mididocs:seq:blm16x16_build_guide [2017/11/24 19:52] (current) – [Dimensions] latigid_on | ||
|---|---|---|---|
| Line 123: | Line 123: | ||
| * Soldering iron, I managed with a normal tip but it’s a bit tricky with some components | * Soldering iron, I managed with a normal tip but it’s a bit tricky with some components | ||
| - | * Solder, probably leaded. 0.5mm will make the finer pitch stuff easier but again I managed | + | * Solder, probably leaded. 0.5mm is strongly recommended for at least the ICs (1206 can be easily done with 1mm solder). |
| * Desoldering wick and/or solder pump. Useful when the pads get too much solder | * Desoldering wick and/or solder pump. Useful when the pads get too much solder | ||
| * Tweezers to pick and place components | * Tweezers to pick and place components | ||
| Line 131: | Line 131: | ||
| * Flat work surface | * Flat work surface | ||
| * Multimeter, test continuity between pads | * Multimeter, test continuity between pads | ||
| + | |||
| + | ==== Dimensions ==== | ||
| + | |||
| + | Here are the dimensions for the button, hole and slider locations. Note that the unmarked mounting holes are M3 (3.2mm diameter) | ||
| + | |||
| + | {{: | ||
| + | {{: | ||
| + | |||
| + | |||
| + | |||
mididocs/seq/blm16x16_build_guide.1459424537.txt.gz · Last modified: 2016/03/31 11:42 by latigid_on