tm5-dindoutgate
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tm5-dindoutgate [2022/12/26 14:25] – [TM5-DinDoutGates] phatline | tm5-dindoutgate [2022/12/28 19:57] (current) – [BOM] phatline | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| {{: | {{: | ||
| - | this is one essential part for my [[triggermatrix5]]\\ | + | \\ |
| - | it gives 24 Digital Inputs, and 32 Digital Outputs, while 16 Outputs are used for UI, the othere | + | **it gives;**\\ |
| + | 24 Digital Inputs\\ | ||
| + | 32 Digital Outputs\\ | ||
| + | * while 16 Outputs are used for UI\\ | ||
| + | * the other 16 are buffered, and are for use as 16 GAte/ | ||
| + | \\ | ||
| The Board is fully SMD, and made for pick and place - so no soldering required!\\ | The Board is fully SMD, and made for pick and place - so no soldering required!\\ | ||
| Line 13: | Line 18: | ||
| ====== Building and BOM====== | ====== Building and BOM====== | ||
| - | Its build by pick and place robots... so no need to build\\ | + | Its build by pick and place robots... so no need to build, or order any component\\ |
| + | you need this PCB 1x for [[triggermatrix5]]\\ | ||
| ===== BOM ===== | ===== BOM ===== | ||
| + | Follwing list is for reference, and debugging only,** no need to order them!** all the parts are already soldered on the PCB!\\ | ||
| ^qty ^reference ^value ^footprint ^jlc^ | ^qty ^reference ^value ^footprint ^jlc^ | ||
tm5-dindoutgate.1672064715.txt.gz · Last modified: 2022/12/26 14:25 by phatline