Differences

This shows you the differences between two versions of the page.

--- enc_4_4 [2018/03/06 07:45] – [BOM v1.0] latigid_on
+++ enc_4_4 [2018/03/06 18:45] – [Dimensions] latigid_on
@@ Line 14: / Line 14: @@
 ^	Type	^	Part	^	Value	^
-|	Caps	|	C25	|	DNF	|
+|Caps   	|	C25	|	DNF	|
 |		|	C26	|	DNF	|
 |		|	C29	|	10uF polarised	|
-|	Encoder	|	EN1	|	12mm	|
+|Encoder	|	EN1	|	12mm	|
 |		|	EN2	|	12mm	|
-|	Header	|	J1	|	PINHD-2X54WALL	|
+|Header  	|	J1	|	PINHD-2X54WALL	|
 |		|	J2	|	+5V	|
 |		|	J5	|	PINHD-2X54WALL	|
-|	OLEDs   |	LCD1	|	0.96_OLED	|
+|OLEDs          |	LCD1	|	0.96_OLED	|
 |		|	LCD2	|	0.96_OLED	|
 |		|	LCD3	|	0.96_OLED	|
@@ Line 47: / Line 47: @@
 ===== Assembly =====
+Decide on the configuration to be used. Any combination of switches, encoders or OLEDs is possible if they fit.
+Only one encoder is wired to the J1 header. If you want to use the EN2 position, wire the legs to the empty EN1 solder points.
+R9 and C29 form the power-on reset for OLEDs. R7 should not be installed. R3/C25/R4/C26 form a termination shunt for OLED data lines. They shouldn't be required.
+The switches accommodate either DT6 or 6mm switches (obviously only one type!). For DT6 switches, ensure the flat side is aligned with the PCB silkscreen.
+J2 can supply power if needed.
@@ Line 53: / Line 61: @@
 ==== Interconnections ====
-  * J1
+{{::scsoled:j1.png?nolink&200|}}
+J1 is the SCS header, connecting to J10A
-===== Dimensions =====
+J2 can provide power as indicated; it is also connected on J5.
-{{:encs:encs.png?link&400|}}
+J5 connects to J15 on the Core (or equivalent)
+===== Dimensions =====
-{{ :encs:encs_dxf.zip }}
+{{:scsoled:scsoled.png?link&600|}}
+{{ :scsoled:doku.zip |}}
 ===== License =====