This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
gm5x5x5_errata [2008/11/22 20:36] fossi.bs created |
gm5x5x5_errata [2010/02/07 11:44] (current) nils |
||
---|---|---|---|
Line 1: | Line 1: | ||
This page lists the know errors on the gm5x5x5 PCBs. | This page lists the know errors on the gm5x5x5 PCBs. | ||
+ | There are no known issues with the bulk order run (white pcbs), the following information is valid **only** for the prototype run (green pcbs). | ||
+ | ==== Bulk Order #1 (white PCBs, rev 1.0) ==== | ||
- | ==== Prototype Run ==== | + | === #1 Silkscreen error (reported by dioioib) === |
+ | |||
+ | **Problem**: The silkscreen has the EEPROM the wrong way around - Pin 1 should be facing IC5. | ||
+ | |||
+ | **Solution**: Stick the EEPROM in the other way around, with the "notch" facing IC5. | ||
+ | |||
+ | ==== Prototype Run (green PCBs) ==== | ||
=== #1 MIDI IO pins === | === #1 MIDI IO pins === | ||
Line 7: | Line 15: | ||
**Problem**: The MIDI IO pins of the midi sockets (Pin 4 + 5) are switched. | **Problem**: The MIDI IO pins of the midi sockets (Pin 4 + 5) are switched. | ||
- | **Solution**: Either (1) sse the pin-headers if you use sockets that are not mounted on the pcb or (2) break the traces to pins 4 + 5 of the sockets and solder wires to them. | + | **Solution**: Either (1) use the pin-headers if you use sockets that are not mounted on the pcb or (2) break the traces to pins 4 + 5 of the sockets and solder wires to them or (3) solder the midi sockets on the other side of the pcb. |
+ | |||
+ | === #2 MISSING TRACK === | ||
+ | |||
+ | **Problem**: A track between D2 and R3 is missing. | ||
+ | |||
+ | {{:err_2.png|}} | ||
+ | |||
+ | **Solution**: Bridge the pins. |