User Tools

Site Tools


xyz-ir-controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
xyz-ir-controller [2020/02/07 00:18] phatlinexyz-ir-controller [2020/02/09 05:14] (current) phatline
Line 3: Line 3:
 or how to DIY\\ or how to DIY\\
  
-{{:phatline:xyz-ausfuehrung.JPG?600|}}\\+{{:phatline:xyz-ausfuehrung.JPG?800|}}\\
  
 ===== Introduction ===== ===== Introduction =====
Line 13: Line 13:
 ==== PCB/Shematic ==== ==== PCB/Shematic ====
 first a took a shot of the Front&Back of the IR-PCB... then i matched it, and redrawed every path...\\  first a took a shot of the Front&Back of the IR-PCB... then i matched it, and redrawed every path...\\ 
-{{:phatline:xyz-pcb-all.JPG?600|}}\\+{{:phatline:xyz-pcb-all.JPG?800|}}\\
  
 i removed the orginal picture:\\ i removed the orginal picture:\\
-{{:phatline:xyz-pcb.JPG?600|}}\\+{{:phatline:xyz-pcb.JPG?800|}}\\ 
 + 
 +==== MB MODs ==== 
 +How to get it working without touching a SERIAL PROTOCOL?\\ 
 +dont using the onboard DACS, instead use the MB-Core STM32F4 J5A AIN-Port....\\  
 +{{:phatline:xyz-pcb-mod.JPG?800|}}\\ 
 +Negative: using a lot of bandwith.\\ 
 + 
 +I connected all 4 IR-Transistor-Circuit directly to J5A\\ 
 +The IR-Diode I connected to Pin1 of J10A.
  
  
xyz-ir-controller.1581034718.txt.gz · Last modified: 2020/02/07 00:18 by phatline